The Kennedy bass amp is available in rack mount cabinet or wood.
The wood cabinet is heavily built, like the electric components, but
also requires more space. The insert board is 9-5/8” and 9" by 24".
Overall length: 26-3/4 inches. The height is 12 inches; room for preamp.
Typical configuration of single channel amp assembly.
To get $100 credit you can build your own cabinet. The 7/8" stock needed:
1 piece 24"X13-1/4 (base) 1 piece 24"X12" (top) 2 pieces 12"x13 sides
Triangle wedge braces: 7 pieces 1-3/4" to 2" inches thick, 1 piece 1-1/4"
4 of the 1-3/4 to 2" braces cannot exceed 3-1/2 inch so they have a flat.
The flat area is at least 1/2 inch wide. This provides a shelf screw-in area
The biscuit cuts offset to allow the top a 1/8 inch ledge where top meets.
Some face plate and back plate stock: wood, acrylic or speaker grill cloth.
All sizes given above are minimal. Figured wood highly recommended
'AMERICAN DECO' or Primo grade cabinet. Lead time depends upon availability of exotic wood. This straight grain facia may require waiting up to a year or more. Shown Padauk wood.
'SURFING SAFARI' or Select grade cabinet. Less lead time due to grain type of exotic wood.
The typical wait to build time for select rare, exotic wood cabinets is 6 weeks to 10 weeks. The magnets attach upper face plate for access to controls, line input jack, effect/preamp. Shown is African Ghaya wood. Upper tray holds rackmount unit, radio receive or cord coils.
